Selected Books:


Buy this book!




Buy this book!




Buy this book!




Buy this book!




Buy this book!



German speakers - order books from amazon.de!

Books to UK - order books from amazon.co.uk!

The Online Requests For Comments - RFCs

Home | Books | Bookmark! | Link to Us | Help

RFC 2175 


Network Working Group                                        K. Murakami
Request for Comments: 2175                                   M. Maruyama
Category: Informational                                 NTT Laboratories
                                                               June 1997


               MAPOS 16 - Multiple Access Protocol over
                    SONET/SDH with 16 Bit Addressing

Status of this Memo

   This memo provides information for the Internet community.  This memo
   does not specify an Internet standard of any kind.  Distribution of
   this memo is unlimited.

Authors' note

   This memo documents MAPOS 16, a multiple access protocol for
   transmission of network-protocol datagrams, encapsulated in HDLC
   frames with 16 bit addressing, over SONET/SDH.  The primary
   difference with MAPOS version 1 is that it has 16 bit address field
   that offers significant wide address space. This document is NOT the
   product of an IETF working group nor is it a standards track
   document.  It has not necessarily benefited from the widespread and
   in depth community review that standards track documents receive.

Abstract

   This document describes the protocol MAPOS 16, Multiple Access
   Protocol over SONET/SDH with 16 Bit Addressing, for transmitting
   network-protocol datagrams over SONET/SDH.  The primary difference
   with MAPOS version 1 is that it has 16 bit address field that offers
   significant wide address space. It first describes the major
   differences between MAPOS and MAPOS 16 briefly. Then, it explains the
   header format and its 16 bit address format.

1. Introduction

   MAPOS is a multiple access protocol for transmission of High-level
   Datalink Control (HDLC) frames over the Synchronous Optical Network /
   Synchronous Digital Hierarchy(SONET/SDH)[1][2][3][4]. It provides
   multiple access capability to SONET/SDH, an inherently point-to-point
   link.

   MAPOS version 1[5] focuses on the frame format compatibility with the
   conventional PPP[6], resulting with its narrow 8 bit address field.
   In contrast to MAPOS version 1, MAPOS 16 has a 16 bit address space.




Murakami & Maruyama          Informational                      [Page 1]

RFC 2175                        MAPOS 16                       June 1997


   In this document, header format and its 16 bit format are described.
   It also explains that 16 bit addressing has minimal influence on the
   conventional MAPOS protocol family such as Node-Switch Protocol[7]
   and Switch-Switch Protocol[8].

2. MAPOS 16 Frame Format

   Like MAPOS version 1, MAPOS 16 framing is based on the HDLC-like
   framing used in PPP-over-SONET/SDH, described in RFC-1662[6].
   However, the address field is extended to 16 bits, and the control
   field in the MAPOS version 1 is omitted for maintain the 32bit
   alignment of the header.

   Figure 2 shows the MAPOS 16 frame format.  Logical Link Control
   (LLC), and Sublayer/Sub-Network Access Protocol (SNAP) are not used.
   It does not include the bytes for transparency.  The fields are
   transmitted from left to right.


           +----------+---------------------+----------+
           |          |                     |          |
           |   Flag   |       Address       | Protocol |
           | 01111110 |        16bits       |  16 bits |
           +----------+---------------------+----------+
              +-------------+------------+----------+-----------
              |             |            |          | Inter-frame
              | Information |    FCS     |   Flag   | fill or next
              |             | 16/32 bits | 01111110 | address
              +-------------+------------+----------+------------

                        Figure 2.  Frame format

     Flag Sequence

     Flag sequence is used for frame synchronization.  Each frame begins
     and ends with a flag sequence 01111110 (0x7E).  If a frame
     immediately follows another, one flag sequence may be treated as
     the end of the preceding frame and the beginning of the immediately
     following frame.  When the line is idle, the flag sequence is to be
     transmitted continuously on the line.

     Address

     The address field contains the destination HDLC address.  A frame
     is forwarded by a switch based on this field.  It is 16 bits wide.
     The LSB of the first byte indicates the continuation of this field,
     and must always be 0. The LSB of the second byte indicates the end
     of this field, and must always be 1.  The MSB of the first byte is



Murakami & Maruyama          Informational                      [Page 2]

RFC 2175                        MAPOS 16                       June 1997


     used to indicate if the frame is a unicast or multicast frame.  The
     MSB of 0 means unicast, with the remaining thirteen bits indicating
     the destination node address including two E/A bits. MSB of 1 means
     multicast, with the remaining thirteen bits indicating the group
     address.  The address 0xFEFF means that the frame is a broadcast
     frame. The address (0x0001) is reserved to identify the control
     processor inside a switch.  Frames with an invalid address should
     be silently discarded.

             +-------------+-+-------------+-+
             | | | | | | | | | | | | | | | | |
             | | node addr |0|  node addr  |1|
             +-+-----------+-+-------------+-+
              ^             ^               ^
              |             |               |
              |             |               +------- EA bit (always 1)
              |             +------- EA bit (always 0)
              1 : broadcast, multicast
              0 : unicast

                        Figure 3 Address format



     Protocol

     The protocol field indicates the protocol to which the datagram
     encapsulated in the information field belongs.  It conforms to the
     ISO 3309 extension mechanism, and the value for this field may be
     obtained from the most recent ``Assigned Numbers'' [9] and ``MAPOS
     Version 1 Assigned Numbers'' [10].

     Information

     The information field contains the datagram for the protocol
     specified in the protocol field.  The length of this field may
     vary, but shall not exceed 65,280 (64K - 256) octets.

     Frame Check Sequence (FCS)

     By default, the frame check sequence (FCS) field is 16-bits long.
     Optionally, 32 bit FCS may be used instead.  The FCS is calculated
     over all bits of the address, protocol, and information fields
     prior to escape conversions.  The least significant octet of the
     result is transmitted first as it contains the coefficient of the
     highest term.





Murakami & Maruyama          Informational                      [Page 3]

RFC 2175                        MAPOS 16                       June 1997


     Inter-frame fill

     A sending station must continuously transmit the flag sequence as
     inter-frame fill after the FCS field.  The inter-frame flag
     sequences must be silently discarded by the receiving station.
     When an under-run occurs during DMA in the sending station, it must
     abort the frame transfer and continuously send the flag sequence to
     indicate the error.

3.2 Octet-Synchronous Framing

   MAPOS 16 uses the same octet stuffing procedure[6] as MAPOS version
   1[5]. Since SONET/SDH provides transparency, Async-Control-
   Character-Map (ACCM) is not used.  HDLC frames are mapped into the
   SONET/SDH payload as follows.

   Each HDLC frame is separated from another frame by one or more flag
   sequence, 01111110 (0x7E).  An escape sequence is defined to escape
   the flag sequence and itself.  Prior to sending the frame, but after
   the FCS computation, every occurrence of 01111110 (0x7E) other than
   the flags is to be converted to the sequence 01111101 01011110 (0x7D
   0x5E), and the sequence 01111101 (0x7D) is to be converted to the
   sequence 01111101 01011101 (0x7D 0x5D).  Upon receiving a frame, this
   conversion must be reversed prior to FCS computation.

4. Influence on MAPOS ARP, UNARP, NSP, and SSP

   Since all of the MAPOS protocol family, ARP[11], UNARP[11], NSP[7],
   and SSP[8], use 32-bit address field for 8-bit MAPOS address, the
   16-bit addressing has no influence on them.  Each protocol only have
   to place a 16 bit address in the least significant place in their 32
   bit address fields as follows;

   (1) MAPOS ARP and UNARP
    16-bit addresses are placed in the least significant places of the
    32-bit sender and target HDLC addresses.

   (2) NSP
    In address assignment packet, a 16-bit address is placed in the
    least significant bytes of the 32-bit address field. The rest of the
    field is padded with zeros.

   (3) SSP
    In route entry of an SSP packet, the 16-bit MAPOS address is placed
    in the least significant bytes of the 32-bit address field.






Murakami & Maruyama          Informational                      [Page 4]

RFC 2175                        MAPOS 16                       June 1997


5. Mapping IP Multicast Address to MAPOS 16 Address

   When transmitting IP multicast[11], the thirteen bits of the HDLC
   address must contain the lowest-order thirteen bits of the IP
   multicast group address.  Exceptions arise when these thirteen bits
   are either all zeros or all ones, in which case the address 1111 1110
   1111 1101 should be used.

6. Security Considerations

   Security issues are not discussed in this memo.

References

   [1]  CCITT Recommendation G.707: Synchronous Digital Hierarchy Bit
        Rates (1990).

   [2]  CCITT Recommendation G.708: Network Node Interface for
        Synchronous Digital Hierarchy (1990).

   [3]  CCITT Recommendation G.709: Synchronous Multiplexing Structure
        (1990).

   [4]  American National Standard for Telecommunications - Digital
        Hierarchy - Optical Interface Rates and Formats Specification,
        ANSI T1.105-1991.

   [5]  Murakami, K. and M. Maruyama, " MAPOS - Multiple Access Protocol
        over SONET/SDH version 1", RFC2171, June, 1997.

   [6]  Simpson, W., editor, "PPP in HDLC-like Framing," RFC1662, July
        1994.

   [7]  Murakami, K. and M. Maruyama, "A MAPOS version 1 Extension -
        Node Switch Protocol," RFC2173, June, 1997.

   [8]  Murakami, K. and M. Maruyama, "A MAPOS version 1 Extension -
        Switch Switch Protocol," RFC2174, June, 1997.

   [9]  Reynolds, J. and J. Postel, "ASSIGNED NUMBERS," RFC1700, Oct.
        1994.

   [10] Maruyama, M. and K. Murakami, "MAPOS Version 1 Assigned
        Numbers," RFC2172, June, 1997.

   [11] Murakami, K. and M. Maruyama, "IPv4 over MAPOS Version 1,"
        RFC2176, June, 1997.




Murakami & Maruyama          Informational                      [Page 5]

RFC 2175                        MAPOS 16                       June 1997


Acknowledgements

   The authors would like to acknowledge the contributions and
   thoughtful suggestions of John P. Mullaney, Clark Bremer, Masayuki
   Kobayashi, Paul Francis, Toshiaki Yoshida, and Takahiro Sajima.

Author's Address

             Ken Murakami
             NTT Software Laboratories
             3-9-11, Midori-cho
             Musashino-shi
             Tokyo-180, Japan
             E-mail: murakami@ntt-20.ecl.net

             Mitsuru Maruyama
             NTT Software Laboratories
             3-9-11, Midori-cho
             Musashino-shi
             Tokyo-180, Japan
             E-mail: mitsuru@ntt-20.ecl.net






























Murakami & Maruyama          Informational                      [Page 6]





RFC Search. Copyright ©1999 by Dodoland Co.
Web design ©1999 by WebYou.com


Selected Books:


Buy this book!



    
Buy this book!



    
Buy this book!



    
Buy this book!



    
Buy this book!